In the reducer family, 56mm planetary gearbox wholesale with its small size, high transmission efficiency, wide deceleration range, high precision and many advantages, and is widely used in servo, stepping, DC and other transmission systems. The correct installation, use and maintenance of the reducer is an important part of ensuring the normal operation of the mechanical equipment. Therefore, when you install 56mm planetary gearbox wholesale, please be sure to strictly follow the following installation and use related matters, carefully assembled and used.

1. Confirm whether the motor and reducer are intact before installation, and strictly check whether the dimensions of the parts connected with the motor and reducer match. Here are the dimensions and tolerances of the positioning boss, input shaft and reducer groove of the motor.

2. Unscrew the screws on the dustproof hole outside the reducer flange, adjust the PCS system clamping ring to align its side hole with the dustproof hole, insert the hex and tighten. After that, remove the motor shaft key.

3, the motor and reducer natural connection. When connecting, it must be ensured that the concentricity of the output shaft of the reducer and the input shaft of the motor are consistent, and the outer flanges of the two are parallel. If the concentricity is inconsistent, it will cause the motor shaft to break or the gear of the reducer to wear.

4, in the installation, it is strictly prohibited to hit with a hammer, to prevent axial force or radial force too much damage to the bearing or gear. Be sure to tighten the mounting bolt before tightening the force bolt.

Before installation, the motor input shaft, positioning boss and reducer connection parts of the anti-rust oil with gasoline or zinc sodium water wipe. Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear. Before connecting the motor to the reducer, make the motor shaft keyway perpendicular to the tightening bolt. To ensure even force, screw the mounting bolts in any diagonal position first, but do not screw them tight. Then screw the other two diagonal mounting bolts and screw the four mounting bolts one by one. Finally, screw the force bolts tightly. All tightening bolts need to be fixed and checked with a torque wrench according to the fixed torsional torque data indicated. The relevant data of the right-angle reducer is not exactly the same as that of the same type of linear reducer, and please pay attention to the user.

In general, the correct installation between the 56mm planetary gearbox wholesale and mechanical equipment is similar to the correct installation between the reducer and the drive motor, the key is to ensure that the output shaft of the reducer is consistent with the concentricity of the driven part of the shaft.

56mm planetary gearbox wholesale https://www.dydzmotor.com/planetary-gearbox